Act today High Check your exposure
Attacker used CyberPower UPS software to run code on a domain controller
Infosecurity MagazineCyberPower · energy
What happened. Infosecurity Magazine reports that Symantec found an attacker using CyberPower's uninterruptible power supply (UPS) software, PowerPanel, to run scripts on a domain controller.
Who is affected. Organisations running CyberPower PowerPanel. The source does not say which versions or organisations are affected.
What to do. Check whether you run CyberPower PowerPanel and on which servers. Review any scripts it has run on domain controllers.
When to act. Act today: Sites running CyberPower UPS software: attackers have used it; check exposure today.
Editor's reading
ForOT security leaddetection engineerIT security
- Purdue level
- L3
- L2
Why: The report describes code running on a domain controller through UPS software. Domain controllers sit at site operations (L3) or in enterprise IT, and can reach plant hosts (L2).
- Are you exposed?
Check your inventory for CyberPower PowerPanel on domain controllers and other servers, and review the scripts it is set to run.
- If you cannot fix it yet
- Restrict PowerPanel management access to a small set of administration hosts.
- Remove PowerPanel from domain controllers where it is not needed.
- Block outbound internet access from the servers that run it.
- Watch for
- Scripts or commands started by the PowerPanel service on a domain controller.
- New or changed PowerPanel scheduled actions or shutdown scripts.
Inferred from the facts above, not stated by the source. Check it against your own site before acting.
Source: Infosecurity Magazine (opens infosecurity-magazine.com)
Published by Industrial Cyber Brief · Editor: Abhinav Roy · Drafted by AI and checked by code: how this is made · Corrections
More on Energy and power